Application

Ready to use with no need to thin. Stir thoroughly before use. Final colour will depend upon timber type, previous treatment and the number of coats applied. Ensure timber moisture content is below 15%. Do not apply in temperatures below 5℃ and above 35°C, in damp conditions (when relative humidity is above 85%), or if rain or dew is likely before the product has dried. If using more than one can, it is advisable to mix them together in a larger container or finish in a corner before starting the new can to ensure colour consistency. On previously stained timber, touch up bare areas first and allow to dry. Avoid heavy wear and tear on the decking for a few days after application. At temperatures below 10°C and when used internally with limited air circulation, the drying process will be delayed. On correctly prepared surfaces, three coats evenly with a good quality brush along the grain, avoiding overlaps. Allow a minimum of 12 hours between coats.

Key benefits

• Deep penetration: low film build
• 2-in-1: no basecoat required
• Luxurious satin finish
• Minimal transformation with colour 078 Natural
• Weather and mould resistant finish
• Withstands physical wear
• Micro porous: allows timber to breath
• Water repellent and slip resistant
• Easy application and maintenance

Technical Information

Finish
Matt
Coverage
Approx. 10-12m2/Litre
Recoatable
Dust dry: After approx. 120 minutes,
Tack free: After approx. 4 hours.
Re-coatable: from 12 hours.
Thinning
None. Ready for use after thorough stirring (thinning will reduce UV protection).